DescriptionIncreases the thermal qualities of your home. EASYSeal Water Seal Plus is a high performance water repellent for all porous building materials. The product can be applied to already damp surfaces which will then, over time dry out, as the coating allows water to escape out and not penetrate in. EASYSeal Water Seal Plus uses technology which is proven to increase Thermal Efficiency, so reducing heating costs. In addition to acting as a water-proofer, it provides a hard wearing, invisible, protective seal against oil, stains, efflorescence, etc on both horizontal and vertical surfaces with no long-term alteration of the colour of the substrate. EASYSeal Water Seal Plus is recommended for the treatment of, walls, fountains, monuments, garden stones and paving, headstones, timber structures, fences and decks.Features include:Penetrating water repellent for porous brickwork, masonry and timberProvides protective seal against water, oil and stainingAllows masonry to breathe so moisture escapesFor use on vertical and horizontal surfacesInvisible coating – no long term textural or colour change5 litres (coverage up to 25m2)Penetrating water repellent for porous brickwork, masonry and timberProvides protective seal against water, oil and stainingAllows masonry to breathe so moisture escapesFor use on vertical and horizontal surfacesInvisible coating – no long term textural or colour changeProven increased thermal efficiency, reduced heating costsBrief usage instructions Application: Use neat as suppliedShake container before useAlways test a small area before use to ensure compatibility and that the finished result is acceptableSurface should be clean. Remove loose dirt, moss and other debris from the surface to be treatedDo not apply in wet or when rain is imminentSurfaces can be dry or damp but not wetIdeal operating temperature between 10ºC and 30ºC. Do not apply during rain, frost or when surface and air temperature is below 5ºCKeep pets away until surface is fully dryClean tools and other equipment with warm soapy waterDo not pour directly onto the surface. The preferred application method is with a low pressure sprayer, but it can be applied with a brush or long haired roller. Apply an even coat and avoid runs and puddlesFor porous surfaces, apply 2 coats. Apply the second coat whilst the surface remains damp from the first coat. Timing depends on temperatures. Allow the product to cure overnight. Optimum performance is reached after 2-3 days, longer in cold, damp conditionsProduct Guide
