DescriptionA solvent free sealer and protector producing a low sheen finish in a single application EASYSeal CONTRACT has been specifically designed with the professional contractor in mind. It seals and protects all types of concrete including Block paving, Raw concrete, Paving slabs, Pattern Imprinted Concrete (PIC) and Garage floors. It penetrates deep into the substrate and delivers excellent oil and water repellent qualities, ensuring the surface is protected from a variety of staining substances. The hard wearing finish enhances the surface colour and extends the life of the substrate. Application is easy – simply apply to the surface with a roller. Applying additional coats increases the protection level and applies a greater sheen to the surface. 5 litres (coverage up to 50m2)Particularly suitable for interlocking concrete & clay blocksReduces ant/insect nuisancesReduces loss of sand by wind & rain (3 coats*)Hard wearing, slip resistant coatingImpedes algae & lichen growthSurface coating withstands sensible pressure washing & detergentsExcellent oil & water repellentStain resistant propertiesResists general dirt & grimeSuitable for internal & external useSurface sealer & sand binder (3 coats*)Solvent free sealer*Note: EASYSeal Contract does contain a sand binder but ideally requires 3 coats to achieve this. If sand binding is essential to your project we recommend you use EASYSeal BCS.How to use Use neat as suppliedThis product is not suitable if surfaces have been previously protected with a sealer. Remove old protective coatings using EASY Sealer Remover before applying this productShake container before useAlways test a small area before use to ensure compatibility and that the finished result is acceptableSurface should be clean. Remove loose dirt, moss and other debris from the surface to be treatedEnsure surface is thoroughly dry before applicationDo not apply in wet or frosty weather or when rain is imminentIdeal ambient and surface operating temperature is between 10? and 20?. As a guide, ensure the surface of the stone is cool to touch. Do not apply in direct sunlight. In hot weather conditions, apply early in the morning before surface temperatures start to rise. Do not apply when the surface temperature is below 5?Keep pets away until surface is fully dryDo not pour EASYSeal Contract directly onto driveway. Use a long pile roller and tray, applying an even coat and avoid runs or puddles by removing excess product from the surfaceFor dense surfaces e.g. block paving, apply 1 coat only where a natural surface finish is required or 2 when a sheen finish is desired. For porous surfaces always apply 2 coats, the second coat within an hour of the first. If an even greater sheen is desired, then a third coat can be appliedOptimum performance is reached after 2-3 days. Allow product to cure overnight before subjecting to heavy use – increase this time in cold, damp conditionsIMPORTANT Do not use on non porous surfaces e.g. quarry tiles, engineering brick, polished or glazed surfaces Product Guide https://www.youtube.com/watch?v=qlCb7uXxZdE
